Table of Contents
Advertisement
Check the Continuity Between the Front and Rear Intermediate Motor Harnesses.
10) Unplug the motor harness (10a) from the rear intermediate motor harness (9b). Refer to figure 8 on page 9.
11) Make sure that the pins are seated properly on 10a. Check the continuity between 9b and 8b.
•
10 ohms or less? – Go to step 15.
•
Open? – Go the next step.
12) Separate the drivetrain from the front frame.
13) Inspect the connection between the front intermediate motor harness (8a) and the rear intermediate motor
harness (9a). Refer to figure 8 on page 9. Make sure the contacts are not corroded. Take a quarter and slide
into the contacts on 8a not marked "+" and "-" on the connector. (Similar to #1 in figure 16 on page 13).
Does each contact hold the quarter firmly in place?
•
No? - Replace the front intermediate motor harness.
•
Yes? - Go to the next step.
14) Check the front intermediate motor harness and the rear intermediate motor harness for continuity.
•
10 ohms or less? – Go to the next step.
•
Open? – Replace as necessary.
Check Resistance at Park Brake.
15) Unplug the park brake (11a) from the motor
harness (10b). Refer to figure 8 on page 9.
Check the pins on the park brake connector (11a).
Make sure they are seated properly.
16) Measure resistance across pin 1 and pin 2
on the park brake (11a) with park brake
engaged. See figure 18.
•
80 ohms or less but not shorted? – Replace
the drivetrain assembly.
•
Shorted or open? – Replace the park brake.
BEEP CODE #6 - PADDLE FAULT (OUT OF NEUTRAL)
This Beep Code means that the throttle control lever was not in the neutral position when the key is turned to the
on position.
1) Turn the key to the off position.
2) Make sure that the paddle pot is not obstructed and it can return to the neutral (center) position.
3) Move the throttle pot forward and then reverse. Make sure that it is not obstructed. Does it spring back
to the neutral position?
•
Yes? – Go to the next step.
•
No? – Check for obstructions. Adjust if necessary. Replace if the adjustment does not work or if
there are no obstructions.
4) Turn the key to the on position. Does the code return?
•
No? – OK
•
Yes? – Go to Beep CODE #7 to test the paddle pot.
Figure 18. Connector 11a
LiteRider_SG_REVA_040711
14
Advertisement
Table of Contents
