Replace the drivetrain
assembly.
Out of that range?
Make sure that the
pins are seated
properly on 10a.
Disconnect 10a from
9b if necessary.
Yes
Take a quarter and slide into the contacts
marked "+" and "-"on the front intermediate
motor harness connector. (See #1 in figure
16). Does each contact hold the quarter
firmly in place?
Measure resistance across
pin 1 (thick red wire) and
pin 2 (thick black wire) on
10a. See figure 26.
Measure resistance across
pin 1 (thick red wire) and
pin 2 (thick black wire) on
10a. See figure 26.
Yes?
Replace the
controller.
50 ohms or less but not shorted?
NOTE: Can be as low as 0.2 ohms.
Replace as
necessary.
Open?
Does each contact
No?
hold the quarter firmly
in place?
LiteRider_SG_REVA_040711
Replace the front
intermediate
motor harness.
40