Table of Contents
Advertisement
Take a quarter and slide into the contacts on
8a not marked "+" and "-"on the connector.
(Similar to #1 in figure 16). Does each
contact hold the quarter firmly in place?
Inspect the connection between the
front intermediate motor harness
(8a) and the rear intermediate motor
harness (9a). Make sure the contacts
are not corroded.
Separate the front
frame from the
drivetrain.
35
10 ohms or less?
Check the pins on the
motor/brake assembly harness
connector 12a. Make sure they are
seated properly.
80 ohms or less but not shorted?
Replace the
controller.
Does each contact
Yes
hold the quarter
firmly in place?
Check the front intermediate motor
harness and the rear intermediate
motor harness for continuity.
Measure resistance across pin 1
and pin 2 (small black wires) on
the motor/brake assembly harness
(12a) with park engaged.
LiteRider_SG_REVA_040711
No
Replace the
front
intermediate
motor
harness.
Open?
Replace as necessary.
Shorted or open?
Replace the
motor/brake
assembly.
Advertisement
Table of Contents
