Table of Contents
Advertisement
2.5k ohms +/- 10%?
Insert the multimeter probes
into the throttle pot connector
(13a) at the orange wire and the
yellow wire. See figure 23.
Note the resistance reading.
Replace the
throttle pot.
Disconnect the control
panel harness (12a) from
the throttle pot (13a).
Insert multimeter probes into
the throttle pot connector
(13a) at the blue wire and
orange wire (outside two
pins). See figure 22.
Insert the multimeter probes
into the main harness connector
at the yellow wire and the
orange wire. See figure 24.
Note the resistance reading.
No
Are both readings
within 500 ohms of
each other?
10 ohms or less on each one?
Replace the
control panel.
Outside that range?
Replace the
throttle pot.
Yes
Check the orange,
blue, and yellow wires
on the main harness
for continuity.
LiteRider_SG_REVA_040711
Open on any wire?
Replace the
main harness.
38
Advertisement
Table of Contents
