Table of Contents
Advertisement
11) Take a quarter and slide into the contacts
marked "+" and "-" on the front intermediate
motor harness connector. (See #1 in figure 16
on page 13). Does each contact hold the quarter
firmly in place?
•
No? - Replace the front intermediate
motor harness.
•
Yes? - Go to the next step.
12) Check the front intermediate motor harness
and the rear intermediate motor harness for continuity.
•
10 ohms or less? – Go to the next step.
•
Open? – Replace as necessary.
Check Motor Resistance at Motor.
13) Make sure that the pins are seated properly on 10a. Disconnect 10a from 9b if necessary.
Refer to figure 8 on page 9.
14) Measure resistance across pin 1 (thick red wire) and pin 2 (thick black wire) on 10a. See figure 26.
•
50 ohms or less but not shorted?
(NOTE: Can be as low as 0.2 ohms). – Replace the controller.
•
Out of that range? – Replace the drivetrain assembly.
BEEP CODE #9 - CONTROLLER FAULT
This Beep Code means that the controller has an internal fault.
1) Remove the key from the key switch and allow the controller to cool down. If the code continues, then replace the
controller.
17
RED
BLACK
Figure 26. Connector 10a
LiteRider_SG_REVA_040711
Advertisement
Table of Contents
