Table of Contents
Advertisement
BEEP CODE #4 - CURRENT LIMIT TIMEOUT
Remove the seat.
Replace drivetrain
assembly or rear
intermediate motor
harness as necessary.
Out of that range?
Replace the
drivetrain assembly.
10 ohms or less?
Replace the
controller.
Remove the battery pack.
Yes
Measure resistance across the
two pins on connector 10a that
have the thick black wire and
the thick red wire (internal
resistance of the motor).
Remove the two screws that fasten the rear floor
mat to the frame and remove the rear floor mat.
Disconnect the front intermediate motor
harness (8c and 8d) from the controller.
Inspect the connection between
the motor/brake assembly (10a)
and the rear intermediate motor
harness (9b).
Are either connectors
discolored or melted?
Disconnect the motor (10a)
from the rear intermediate
motor harness (9b).
Remove the floor basket.
Make sure that the pins are seated
properly on 9b. Check the
continuity between 8c/8d and 9b.
LiteRider_SG_REVA_040711
No
50 ohms or less but not shorted?
Note: Can be as low as 0.2 ohms.
Replace the seat.
Open?
32
Advertisement
Table of Contents
