Table of Contents
Advertisement
BEEP CODE #7 - PADDLE POT/SPEED CONTROL FAULT
This Beep Code occurs because there is a fault with the throttle pot,
speed pot, or the associated wiring.
Check Throttle Pot Resistance at Controller.
1) Remove the seat.
2) Remove the floor basket.
3) Remove the two screws that fasten the rear floor
mat to the front frame.
4) Turn the speed pot to full rabbit.
5) Set your multimeter to measure resistance.
6) Disconnect the main harness (7a) from the
controller. Refer to figure 8 on page 9.
7) Insert multimeter probes into the main harness
connector 7a at pin 8 and pin 2 (blue wire and
orange wire). See figure 19.
•
2.5k ohm ±10%? - go to the next step.
•
Outside that range? - Go to step 9.
8) Insert the multimeter probes into the main
harness connector 7a at pin 1 and pin 8
(blue wire and yellow wire). See figure 20.
Note the resistance reading. Insert the
multimeter probe into the main harness
connector at pin 1 and pin 2 (yellow wire and
orange wire). See figure 21. Note the resistance reading.
•
Are both readings within 500 ohms of each
other? - Replace the controller.
•
Are either readings outside that range? - Go
to the next step.
Check Throttle Pot Resistance at Throttle Pot.
9) Open the control panel.
10) Disconnect the control panel harness (12a) from
the throttle pot (13a). Refer to figure 8 on page 9.
11) Insert multimeter probes into the throttle pot
connector (13a) at the blue wire and the orange
wire (outside two pins). See figure 22.
•
2.5k ohm ±10%? - go to the next step.
•
Outside that range? - Replace the throttle
pot.
15
7a FRONT
Figure 19. Connector 7a
7a FRONT
Figure 20. Connector 7a
7a FRONT
Figure 21. Connector 7a
Figure 22. Connector 13a
LiteRider_SG_REVA_040711
Advertisement
Table of Contents
