Golden LiteRider GL140 Service Manual page 40

Table of Contents

Advertisement

BEEP CODE #8 - MOTOR VOLTAGE FAULT (OPEN/SHORTED)
Remove the seat.
50 ohms but not shorted?
NOTE: Can be as low as 0.2 ohms.
Replace the
controller.
Open?
Remove the
battery pack.
Yes
Replace as necessary.
39
Remove the floor
basket.
Remove the two
screws that fasten the
rear floor mat to the
front frame.
Measure resistance across
the front intermediate
motor harness 8c and 8d.
See figure 25.
Make sure that the pins are
seated properly on 9b.
Check the continuity
between 8c/8d and 9b.
Separate the
drivetrain from
the front frame.
Inspect the front and rear
intermediate motor harness
connectors. Are they discolored
or corroded?
Remove the two screws
that fasten the rear floor
mat to the front frame.
Out of that range?
Unplug the motor/brake
assembly from the rear
intermediate motor
harness.
10 ohms or less but not shorted?
No
LiteRider_SG_REVA_040711

Advertisement

Table of Contents
loading

This manual is also suitable for:

Literider gl110

Table of Contents