Table of Contents
Advertisement
KEY
4 Controller Enclosure
5 Flow Meter Cable; connect as shown in Fig. 4
6 Ground wire connection point for solenoid
enclosures
grounding
mounting surface's grounding wire.
7 Manifold Mounting Surface Ground Wire; must
be connected to same true earth ground (8) as
controller.
8 True Earth Ground; check your local code for
requirements.
9 Controll Enclosure Grounding Wire; must be
connected to same true earth groun (8) as
manifold mounting surface is connected to.
10 Controller Enclosure's Grounding Lug
11 Controller Grounding Wire (green-yellow wire);
connect to controller enclosure's grounding lug
(8)
12 Controller
Fig 5
Connect Other Wiring
Connect the 24 VDC meter cables to terminals
inside the controller enclosure as shown on the
prints provided by Graco.
684-015
Installation
wire
and
manifold
Connect The Pendant
Connect the pendant cable to the 9-pin controller
connector marked PENDANT.
NOTE:
The NEMA enclosure bulkhead has a 6-pin
connect for the pendant.
9
Advertisement
Table of Contents
