CPI GRYPHON User Manual page 26

Connect the CPI Synq™ device to Gryphon™ coin changer
The CPI Synq device can be installed in series, anywhere on the MDB line that makes it
easy for you to operate. Both ends of the MDB must be connected to power up, and the CPI
Synq device must be connected to the CPI Synq device port on the Gryphon coin changer to
communicate with the devices.
If there is a CPI Synq device cable pre-installed on your Gryphon coin changer, simply
connect the CPI Synq device to the pre-installed cable. If there is not a CPI Synq device
cable pre-installed, you will need to remove the PCB cover behind the validator module.
1. Lift up on the yellow tab and pull the validator module forward.
2. Press down on this tab to remove the PCB cover.
3. Connect the CPI Synq device cable to this port.
Gryphon
™
© 2021 Crane Payment Innovations.
All rights reserved.
Coin Changer User Guide
EN 26