Step 3: Select Measurement Mode - ADC ADView 2 9005BPSTO User Manual

Turn the Selection Knob in either direction to select the desired icon
After making your selection, wait 2 seconds. The selected icon will be the one flashing.
Once you have selected the intended mode, press the Selection Knob to finalize this selection.
Note: Adult and Pediatric mode can be used in conjunction with any type of measurement mode.

Step 3: Select Measurement Mode

The ADView 2 offers three different ways to measure BP.
Single Measurement Mode: You can take a single, automatic measurement.
Averaging Measurement Mode: Automatically take and average up to 5 multiple BP measurements.
Manual Mode. Allows you to verify an automated oscillometric BP reading with a manual auscultatory measurement.
Note: Use of Manual Mode may be required to meet certain clinical trial protocols. It also can be used to verify a BP
reading if the automated BP results diverge significantly from a patient's prior history, or if you as the clinician deem
it necessary. Manual Mode mimics a traditional sphygmomanometer and does not measure Systolic or Diastolic
blood pressure.
Note: Averaging Measurement Mode can only be used for Automatic BP Measurements. It cannot be used to
automatically average measurements taken in Manual Mode.
Single Measurement Mode
This is the device's default mode. The ADView 2 will be in this mode each time it is powered up.
Pressing the Home button will also revert to single measurement mode.
Example of center display when Single Measurement Mode is selected
Note: If you see the Auscultatory SphygMode Icon or the Averaging Mode Icon , press the Mode Toggle Button
in succession until these icons no longer show to return to Single Measurement Mode.
93-9005-00 rev 4
ADView 2 User Manual | 22
September 1, 2016