Table of Contents
Advertisement
For ChipOx:
Attach the ChipOx SpO
sensor to the connector on the module while the retention clip is held upwards. Once the
2
sensor/cable connector is inserted, push the clip downward over the connector to hold it securely in the module. For
easy insertion, ensure the cable plug is parallel to the device.
For Masimo:
Attach the Masimo extension cable to the connector on the module, making sure that the connectors lock together.
Then, attach the Masimo SpO
sensor to the other end of the extension cable making sure that the retaining clip is in
2
place.
Install Batteries
The rechargeable lithium-ion battery is installed prior to shipping. Please allow 8 to 12 hours for charging before
using your unit. All segments of the Battery Symbol will be lit when the device is fully charged.
CAUTION: Fire, explosion and severe burn hazard. Replace only with ADC part number9005BAT.
If not installed in the device, the battery shall be kept away from heat, fire or other high temperature environments.
Keep the battery in a dry place stored at room temperature.
Do not disassemble, attempt to repair or use the battery for any other device or for any other purpose.
Do not place near any metal or use metal to shield the battery from physical damage as this may cause battery
overheating and/or a fire risk.
Do not short across the contacts of the battery or attempt to discharge the battery by shorting as a risk of fire or
explosion may result.
Do not expose or immerse the battery in water or attempt to clean with any cleaning agents. Only wipe battery with a
damp cloth if necessary.
Wash the affected area if electrolyte spills on skin or clothes. Leaking electrolyte may cause discomfort to the skin. If
it gets into the eyes, do not rob the eyes. Flush eyes immediately with water, and seek medical attention.
Battery Disposal
The ADView 2 has a lithium-ion battery that contains materials which may be hazardous to human health. Do
NOT dispose of battery in domestic waste! Instead, please dispose of in an environmentally responsible way, or
return the battery to ADC. A prepaid return label can be obtained. Please see our website for more information.
93-9005-00 rev 4
ADView 2 User Manual | 13
September 1, 2016
Advertisement
Table of Contents
