Features And Controls; Engine Pull Starter; Engine Electric Starter; Throttle Lever - Billy Goat BC26 Operator's Manual

Features and Controls

Engine Pull Starter

Note: Check engine oil and fuel levels before attempting to
start the engine! Add oil and/or fuel, if necessary.
Fits: Non-Electric Units.
Pull the starter rope to start the engine. Pull the starter cord
slowly until resistance is felt. Then, pull the cord rapidly to
avoid kickback.

Engine Electric Starter

Fits: BC2601HEBH, BC2601HEBHFT units
The engine electric starter (A, Figure 5) is located on the right
side of the upper handle. Turn the ignition key to start the
engine. If the engine does not immediately start, crank over
the engine for only ten (10) seconds at a time. Cranking the
electric engine starter for longer increments of time can cause
damage to the engine.
5

Throttle Lever

The throttle lever (A, Figure 6) increases the engine speed.
Before starting the engine, depress the throttle lever. Depress
the lever completely (A, Figure 7) to reach top engine speed.
6
7

Drive Handle

Fits: Mechanical drive models
Squeeze the mechanical drive handle (A, Figure 8) to engage
the unit in motion. Before engaging the drive lever, use the
direction shifter to select forward or reverse motion.
5