Identifying Your Unit; Intended Use; Initial Setup; Installing The Handle Assembly - Billy Goat BC26 Operator's Manual

Identifying Your Unit

Thank you for purchasing this quality piece of outdoor
power equipment. Before operation, please note the
product Identification Tag (A, Figure 1) which is found at the
operator's position, below the handlebars.
1
Record your model number, serial number, and engine model
and serial numbers in the space provided for easy access.
PRODUCT REFERENCE DATA
Unit Model Number:
Unit Serial Number:
Dealer Name:
Date Purchased:
ENGINE REFERENCE DATA
Engine Make:
Engine Model:
Engine Type/
Specifications:
Engine Code/Serial
Number:
When contacting your authorized service dealer for
replacement parts, service, or information you MUST have
these numbers.
Note: For the location of the engine identification numbers,
refer to engine owner's manual.

Intended Use

This machine may only be utilized for the purpose for which
it was designed. This machine is designed to cut brush. Be
sure that all operators of this equipment are trained in general
machine use and safety.

Initial Setup

Installing the Handle Assembly

Fits: Units shipped in cardboard carton/box.
1. Locate the handle assembly (A, Figure 2). Be mindful of
cables when handling.
2
2. Install the handle assembly onto the frame (B). Use the
four bolts (C), washers (D), and nuts (E) to secure the
upper handle assembly to the lower handle assembly. Be
mindful of the cables.
3. Install the blade cable (A, Figure 3). First, connect to the
blade cable bracket (B). Then, install the cable onto the
blade lever (C). Use the bolt (D), washer (E), and nut (F)
to secure the cable to the lever.
3