Table of Contents
Advertisement
SC180H Owner's Manual
PACKING CHECKLIST
Your Billy Goat Sod Cutter is shipped from the factory in one crate, completely assembled.
READ all safety instructions before assembling unit.
TAKE CAUTION when removing the unit from the box.
PUT OIL IN ENGINE BEFORE STARTING
CHECK GREASE IN BEARING PER SERVICE LABEL ON UNIT. ADD GREASE AS REQUIRED. USE NLGI GRADE 2
MULTIPURPOSE LITHIUM BASE GREASE
PARTS BAG & LITERATURE ASSY
Warranty card P/N- 400972, Owner's Manual P/N-371500, Declaration of conformity P/N- 371509, General Safety and
Warranty manual P/N- 100295
OPERATOR CONTROLS
DRIVE CONTROL: Located on the right hand side of
the handle bars. When engaging the drive lever, pull it
till it comes into contact with the handle bar. Do not
halfway engage the drive as this will cause premature
failure of the transmission. (See Fig. 1)
BLADE ENGAGE LEVER: Located on the left hand side
of the handle bar. As with the drive lever, it must be fully
engaged when in use.
SPEED AND DIRECTON SHIFTER: Lift the levers
located on either side of the shifter control then move
the shifter control forward or backward to select the
desired direction and speed then release the levers. DO
NOT push the shifter control without releasing the levers
as this will cause damage to the shifter control. (See
Fig. 2)
FREE WHEEL LEVER: Located on top of machine next
to the height adjust. Pull the lever out to free wheel and
push it in to allow the drive to be engaged. (See Fig. 3)
Part No 371508
Boxing Parts
Checklist
Honda 5.5 HP
engine
Fig. 1
5
Fig. 2
Fig. 3
Form No F102215A
Advertisement
Table of Contents
