Operator Controls - Billy Goat SC181HGEU Owner's Manual

Operator Controls

Drive Control: The ground drive controls are located on each handlebar of the machine. The right side lever
control moves the machine forward at varying speeds depending on how far the operator engages the control.
The left side lever control moves the machine in reverse at varying speeds depending on how far the operator
engages the control. (While either control is engaged, the opposite control is "locked out")
(See Fig. 5)
Blade Engage Lever: Located on the left hand side of the handle bar. It must be fully engaged when in use.
Blade Height Adjustment: : Pre-select cutting depth by inserting depth control pin in the hole which corre-
sponds to the depth desired. A chart is provided on a placard near the blade depth control handle. To set
depth while using the machine loosen cam lever clamping the depth control handle in the "up" position. Rock
the machine forward to allow the cutting blade to drop to the pre-selected depth. (The depth control handle
should rest against the depth control pin). You are now ready to start cutting sod.
(See Fig. 2)
Free Wheel Lever: Located on top of machine next to the height adjust. Pull the lever out to free wheel and
push it in to allow the drive to be engaged. (See Fig. 6)
Fig 2.
Fig. 6 HEIGHT ADJUST P/N 373503
DRIVE ENABLE P/N 373504
Fig. 5
CONSOLE P/N 373500
Part No. 373507 373507_A_HI
7