Binding - Horizon Hobby Spektrum Firma SPMXSER1025 Manual

Binding

This receiver can bind to either DSM or SLT transmitters.
DSMR or DSM2
1. Connect a battery but leave the power switch OFF.
2. Press and hold the bind button on the receiver.
3. Throttle should be at neutral to set failsafe. Power ON the
receiver. The red and green LEDs both flash, indicating the
receiver is in bind mode. Release the bind button after the
LEDs begin to flash.
4. Put your transmitter in bind mode.
5. The bind process is complete when the green LED on the
receiver remains lit. The motor emits a Spektrum 4 tone
cycle, confirmation of battery cell count tones and a rising
confirmation tone.
SLT
1. Begin with no battery connected.
2. Throttle should be at neutral to set failsafe.
3. Connect a battery to the receiver and immediately press and
release the bind button on the receiver three times rapidly
(within 1.5 seconds of powering ON).
4. The red and green LED flashes, indicating the receiver is in
bind mode.
5. Put your transmitter in bind mode.
6. The bind process is complete when the green LED on the
receiver remains lit. The motor emits a Spektrum 4 tone
cycle, confirmation of battery cell count tones and a rising
confirmation tone.
10