Transmitter And Receiver Binding - Horizon Hobby Spektrum AR637T Manual

EN
ANTENNA INSTALLATION
The AR637T receiver has coaxial style antennas.
We recommend installing the antennas oriented
90º from each other and as far as possible from
metal, batteries, carbon fi ber or fuel tanks to
maximize signal reception performance.
NOTICE: Do not cut, kink, or modify the antennas. Damage to the coaxial
portion of an antenna will reduce the performance of the antenna.
Shortening or cutting off the 31mm tip will reduce the range.

Transmitter and Receiver Binding

Programming the AR637T receiver requires a Spektrum
compatible transmitter with Forward Programming.
Binding
The AR637T receiver must be bound to your transmitter before it will operate.
Binding is the process of teaching the receiver the specifi c code of the transmitter
so it will only connect to that specifi c transmitter.
1.
Connect the optional SRXL2 remote receiver (SPM9747) if desired and any
telemetry sensors to the main receiver.
2.
Push and hold the bind button on the receiver while turning the receiver on.
Release the bind button once the orange LED starts to fl ash continuously,
indicating the receiver is in bind mode.
TIP: It is still possible to use a
bind plug in the bind port if
desired. This can come
in handy if the receiver
needs to be mounted in
a location that is diffi cult
to access, in which case a
servo extension may be used for
binding. If using a bind plug, remove
after binding to prevent the system from
entering bind mode the next time the power is
turned on.
3.
Put your transmitter in bind mode.
4.
The bind process is complete when the orange LED on the receiver is solid.
6
Active portion
of antenna
™ ® ®
DSM2 /DSMX