Binding And Calibrating - Horizon Hobby Spektrum Smart Technology SR6200A Instruction Manual

EN

BINDING AND CALIBRATING

Binding is the process of linking the SR6200A receiver to your Spektrum
transmitter. The AVC features on the receiver can be enabled or disabled during
the binding process. There is no bind plug on the SR6200A, a button is used to
put the receiver in bind mode.
IMPORTANT: You must calibrate the SR6200A receiver each time it is placed
in bind mode, regardless of AVC being enabled or disabled.
BINDING AND CALIBRATION PROCESS
Upon initial setup after the first bind, the model must be configured for servo
direction, trim and travel. Then the receiver must be rebound and calibrated to
those settings for proper operation. Center the steering trim and throttle trim on
the transmitter before beginning.
1.
Press and hold the bind button on the receiver.
2.
Power on the receiver. The orange LED flashes, indicating the receiver is in
bind mode. Release the bind button after the orange LED illuminates.
3.
Put your transmitter in bind mode.
4.
The bind process is complete when the orange LED on the receiver
remains lit. At this stage the receiver is connected but must complete
calibration before it will operate.
5.
Pull the transmitter trigger to full throttle, pause, then return the trigger to
center.
6.
Push the transmitter trigger to full brake, pause, then return the trigger to
center.
7.
Turn the transmitter steering wheel to full right, pause, then return the
wheel to center.
8.
Turn the transmitter steering wheel to full left, pause, then return the
steering wheel to center. The orange LED flashes to confirm the settings
have been accepted.
9.
Turn off the vehicle to complete the binding and calibration process.
CAUTION: When the bind process is complete, the throttle and
steering channels are active. Keep hands and loose objects away
from all spinning parts on the vehicle.
6
Bind Button