Led Indicators - Horizon Hobby Spektrum Firma SPMXSER1025 Manual

3. With the vehicle and receiver powered off, plug the updater
cable into the programming port on the 2-in-1. DO NOT turn
on the vehicle or receiver when the USB cable is connected.
The PC should connect with the receiver automatically.
4. Follow the on screen prompts in the to install the firmware
file on the 2-in-1.
5. When the update is complete, unplug the updater cable
from the receiver.

LED Indicators

Upon powering ON the ESC, the red LED will blink and the motor will
emit a series of beeps to indicate its status.
The number of tones indicates (1) the ESC is in operation (2) the
battery mode detected and (3) the ESC is in a ready-to-use state.
Feature
1. ESC is in operation
2. Ni-MH/Ni-CD Battery
2S Li-Po Battery
3S Li-Po Battery
3. ESC ready
no transmitter signal
DURING OPERATION
Stop
Forward partial throttle
Full Throttle
Reverse partial throttle
Full Throttle
Partial Brake
Full Brake
Battery Low Voltage or No Signal
Overheat
Over Current Protection
Red LED Status
Rapid blinking
1 Blink
2 Blinks
3 Blinks
Red blink
repeating
Green Solid, Red Blinks
Green Solid, Red Blinks
Green Solid, Red Blinks
Red Double Blink Repeating
Red Triple Blink Repeating
Motor Sound
4 Changing tones
1 Short tone
2 Short beeps
3 Short beeps
LED STATUS
Green Solid
Green and Red Solid
Green and Red Solid
Green and Red Solid
Red Blink Repeating
17