Esc Programming - Horizon Hobby Spektrum Firma SPMXSER1025 Manual

ESC Programming

The ESC in the 2-in-1 may be programmed via the push button
on the switch, or with the optional SPMXCA200 Program Card.
To change settings with the programming button:
1. Power ON your transmitter. Connect a battery to the ESC
and power it ON. The transmitter and receiver must be
connected.
2. Press and hold the programming button for 1 second.
OPTIONAL: Press and hold the programming button for 5
seconds to reset all ESC programming options.
3. Release the programming button, the red LED will blink to
indicate it has entered programming mode
4. The red LED blinks (and the motor beeps) to indicate the
programming item. Press the programming button for one
second in order to toggle through the programmable items.
1 red LED blink for item one, 2 red LED blinks for item 2 etc.
For item 5 and above, one long LED blink for item 5, one
long LED blink and 1 short LED/blinks for item 6 etc.
For items 10 and above, 2 long LED blinks for item 10, 2
long LED blinks and 1 short LED/blinks for item 11 etc.
5. Press and hold the programing button for 3 seconds when
you want to enter a programming item.
6. The LED blinks to indicate the programming value within the
item selection.
7. Press and hold the programming button for 3 seconds when
you want to select a programming value.
8. Power off the ESC.
9. Begin the process again to change any other
programming values.
13