Maintenance - Omcan BE-IT-0015M Instruction Manual

Maintenance

DAILY MAINTENANCE
To clean the machine daily, follow the phases as outlined below:
1. Remove the fastening pin of the cutting unit.
2. Open the cutting unit accompanying it to the support.
3. Release the divider handle and lower the pressure handle. The knife exits.
4. Once the knife is cleaned, reposition the pressure handle in the rest position. Close the cutting unit.
5. Insert the fastening pin of the cutting unit.
PERIODIC MAINTENANCE
To ensure the machine works properly and, in particular to ensure a long life, you are advised to periodically
clean the ring on the head. The stainless steel parts, the painted covers, the polyethylene PE500 and the
plates in PETG can be easily cleaned with water and soap or a neutral detergent, then you need to rinse them
with plenty of water and dry them with a soft cloth.
1. Open the cutting unit accompanying it to the support.
2. Remove the two casings of the cutting unit by unscrewing the fastening screws.
3. Remove the ring fastenings (x2).
4. Remove the ring and clean it inside with a plastic scraper.
5. After cleaning, re-position the ring and fasten the relevant locks.
6. Close the cutting unit and insert the fastening pin.
10