Peavey TubeFex Operation Manual page 53

This is the command to edit the effect chain. Pram is a number between 0 and 7 which corresponds to the
location of the parameter in the effect. The data corresponds to each effect as follows:
(all numbers in hexadecimal)
Data
00 = End of Chain
01 Compressor
02 =
Distortion
Overdrive
chorus
Delay
Pitch 1
07 Pitch 2
08 = Reverb
Classic EQ
OA =
OB =
oc =
OD = Hum Filter
OE = Coil Tap
OF = Exciter
10
Envelope Filter
11 Pan
12
Speaker Simulator
Stereo Simulator
Noise Gate
Effects Loop
Splitter
Tube
Tremolo
FF = End of Left (top) path
Important note to programmers: When adding a splitter to the chain, add the splitter at the desired
location, then be sure to add an End of Left Path in the position following the last desired effect for the left
path. Right path effects follow this marker. When deleting the splitter from the chain, the end of left path marker
must be replaced with an End of Chain marker before replacing the splitter with another effect.
D-2
Appendix D Remote Editing with SysEx