Peavey TubeFex Operation Manual page 36

The Compressor effect suppresses high input levels while boosting small signal levels as the input decreases.
The net result is a more consistent output volume and increased sustain.
I n p u t N -
Parameters
The Atk (Attack) parameter adjusts the speed at which the compressor responds to increases
in signal
The (Release) parameter adjusts the time for the output signal to decay. Range is from
X Slow X Fast.
to
to X Slow results in a very slow decay.
The Sus (Sustain) parameter provides seven levels of sustain to vary the maximum amount of gain
that can be achieved by the compressor at small signal levels. Range is O-6.
Lev
The (Level) parameter adjusts the maximum output of the compreS.sor. Range is 0400%.
with no signal present. The
suppression on the output. Range is
The Distortion effect consists of a digital distortion followed by an equalizer section. This is a mono effect.
Parameters
Dr
The (Drive) parameter- controls the amount of distortion by pre-filtering and boosting the input
signal. Range is O-100.
The Ps
section of the effect. Range is 0-
Ft
The (Fat) parameter controls the low frequency gain. Parameter range &50.
Ft.
The Ed
Bd
(Body) parameter controls the mid fbquency gain. Range is *SO.
A-4
Compressor ccn)
C o m p r e s s o r L -
(Sustain)
(Level)
from X Slow to X Fast.
Setting the release to X Fast
(Noise Gate Threshold) parameter provides ten levels of noise
Distortion (IDS)
100.
1
N o i s e
output
Gate
.
results in a very rapid decay, while setting the release
Appendix A