Peavey TubeFex Operation Manual page 49

Parameters
Send: The Send (Send Level) parameter determines the level of the signal that is sent to the Effects Send
jacks. Range is O-100.
The Dir (Direct Level) parameter determines the level of the direct signal that is mixed with the
input from the effect loop returns. Range is
Rtn
The (Return Level) parameter determines the level of the signal that
chain. Range is O-100.
Sum
Sum: The (Summed Return Level) parameter turns
stereo returns with the analog output from the digital effects.
The splitter/hi-amp effect enables you to split the stereo signal into two separate chains, placing different effect
types on each chain. The signal following the splitter is MONO and only appears on one channel. Therefore,
note that the signal on the LEFT path (top line) only passes through the LEFT half of effects following the
splitter, and the signal on the RIGHT path (bottom line) only appears on the RIGHT channel of effects
following the splitter.
Effects
Parameters
The (Balance) parameter controls the righ #'left balance of the splitter output. This works like
a normal stereo balance where the signal output from both sides is 100% at a balance of
0, 100% of the right signal is passed through and none of the left signal is passed; at 100, 100%
of the left signal passes and none of the right signal is passed.
This is a high pass filter that allows frequencies higher than the specified frequency to pass to the
left channel. Range is 20
This is a low pass filter that allows frequencies lower than the specified frequency to pass to the
Lo-R:
right channel. Range is 20
Appendix A Individual Effects
High Pass Filter
Balance
I
SPLITTER
and
Hz to 3.3 This parameter is not available when
Hz to 3.3 This parameter is not available when
returned to the effects
is
OFF
and an analog switch that sums the
ON
E f f e c t s
E f f e c t s
Left Out
Right Out
50; at
SPLITTER is used.
SPLITTER is used.
A-17