Table of Contents
Advertisement
CHAPTER 4: CARE & MAINTENANCE
If the running belt is too far to the left side:
•
Locate the belt adjustment bolts in the rear end caps of the
treadmill. (To determine left and right, stand at the rear of the
•
Using the appropriate size Allen wrench or socket turn the LEFT
turn.
•
Turn the treadmill on and start the belt at 3mph keeping off the
•
Allow 2 minutes for the belt to adjust itself.
•
Repeat the above steps if additional adjustment is necessary.
Note: After the running belt alignment is complete, confirm the Allen wrench has been removed from the adjustment bolt
in the front belt cover before further use.
TENSIONING THE RUNNING BELT:
If there is a slipping or jerking sensation when running on the treadmill, the running belt may require tightening. In most
cases the belt has stretched from use. Tensioning the belt takes a few simple adjustments. If you are unsure about this
procedure, call the TRUE Service Department.
•
Locate the belt adjustment bolts in the front belt cover.
•
Remove the rubber cover plugs.
•
Using the appropriate size Allen wrench or socket,
turn BOTH adjustment bolts clockwise 1/4 turn.
•
Turn the unit on, start the belt, and check if the slipping
continues.
•
Repeat the above steps if additional adjustment is necessary.
Note: After the running belt tensioning is complete, confirm
both Allen wrenches have been removed from the adjustment
bolts in the front belt cover before further use.
Truefitness.com / 800.426.6570 / 636.272.7100
treadmill and face the display).
adjustment bolt clockwise 1/4
unit.
32 of 50
Advertisement
Table of Contents
