Epson PH890 Service Manual page 160

EPSON Stylus Photo 890/1290
Table 6-2. Lubrication Point (continued)
Lubrication Point
15 Contact areas for ROLLER, PF and
PAPER GUIDE, REAR
• Apply the grease to the contact area while
rotating the shaft.
NOTE: Do not get the grease on the
specially coated area of ROLLER,
PF.
16 PAPER GUIDE, FRONT (6 points)
• Lubricate slots(4) and hooks(2) of Paper
Guide Front with G-26 using syringe.
SHAFT, CR
17
• Apply G-56 on Shaft, CR (2 spots).
• After applying the grease, move the
Carriage to left to right to distribute the
grease evenly on the shaft.
18 COMBINATION GEAR 13.5, 30 shaft in
FRAME, LEFT
MAINTENANCE
Lubricant Type &
Refer to:
Amount
G-26 Page 164
φ
1 x 1/2 of the
circumference
G-26 Page 164
φ
• 1 x 2mm
(Eject Roller side-
[2])
φ
• 1 x 10mm
(PF Roller side[1])
φ
• 1 x 2mm([2] hooks
& [1] slot)
G-56 Page 165
G-26 Page 165
φ
1 x 5mm
Overview
Table 6-2. Lubrication Point (continued)
Lubrication Point
19 LD Roller Assy hole in the FRAME, ASF;
B
• Using a brush, apply the grease evenly to
the entire inside surface of the hole.
20 Latches (right & left) in the Hopper Assy
along which the hopper release levers turn
(2 spots).
• Use a brush to apply the grease.
21 GUIDE PLATE, CR
• Apply the grease to the Carriage using the
Guide Place CR Lubricating jig.
• Spread the G-26 evenly by moving the
Carriage once.
n
Never apply oil directly to the CR guide shaft. This may cause a
W A R N I N G
fatal damage to the main components of the printer.
n
Avoid applying too much oil to the oil pad. Otherwise, you may
critically damage the main components of the printer.
Revision B
Lubricant Type &
Refer to:
Amount
G-26 Page 165
φ
1 x 1mm
G-26 Page 166
A 2-mm wide bead for
each one.
G-26 Page 166
φ
1 x 270mm(See the
figure for length.)
160