Check Present Adjustment Data - Epson PH890 Service Manual

EPSON Stylus Photo 890/1290
5. When you adjust the setting values, make sure that the Bi-D gap becomes less than
60 µ m.
Bi-d
MS Color
data = -14
Figure 5-29. Bi-D Adjustment Printing Example
6. After changing the values, click OK. The following message appears on the
window and the Input Bi-D Adjustment Value is completed.
Figure 5-30. Input Bi-D Adjustment Value Completed
7. To continue with other mode, click Previous and select a different item. Print the
Bi-D Adjustment Patterns if necessary.
8. Repeat the steps from 1 to 7 until you get the best result.
ADJUSTMENT
Bi-D Gap
µ
Less than 60 m
Individual Adjustment Program
9. To exit or continue the program, click Quit on the lower left. Refer to Figure
5-17."Exit Window" on page -133.

5.3.2.2 Check Present Adjustment Data

1. Start the program and input all the required information on the initial window.
Then the main menu appears on the screen. (See 5.2.4.1"Adjusting Program Initial
Setting" on page -131)
2. Select Bi-D from the main menu.
3. The Bi-Directional Adjustment window appears. Select Check Present
Adjustment Data and click
OK
Figure 5-31. Bi-Directional Adjustment Window
Revision B
.
138