EPSON Stylus Photo 890/1290
4.2.8 MOTOR ASSEMBLY, ASF Removal
1.
Remove HOUSING (Refer to Section 4.2.1.)
2.
Remove the harness for MOTOR ASSEMBLY, ASF from the main board. (Refer
to Section 4.2.2.)
3.
Lower LEVER, PLANETARY UNIT.
[Lever is held up.]
Figure 4-21. Setting LEVER, PLANETARY UNIT
4.
Remove 2 screws (CBP, 3x8) securing MOTOR ASSEMBLY, ASF to
BRACKET, MOTOR, ASF. Then push the motor assembly to the rear and then to
the right to remove it.
DISASSEMBLY AND ASSEMBLY
LEVER, PLANETARY
[Lever is lowered.]
Disassembly Procedures
BRACKET, MOTOR, ASF
Figure 4-22. MOTOR ASSEMBLY, ASF Removal
C H E C K
When installing MOTOR, ASSEMBLY, ASF5, make sure the
P O I N T
DE unit and LEVER, PLANETARY UNIT are set as shown
below:
DE Unit (BRACKET,
MOTOR, ASF)
LEVER,
PLANETARY UNIT
Revision B
MOTOR ASSEMBLY, ASF
CBP (3x8)
97