Table of Contents
Advertisement
2.1
Introduction
The following sections show the internal jumper settings and the external connector
pin assignments for different applications.
2.2
Jumpers
2.2.1
Jumper Description
You may configure EIS-S232 to match the needs of your application by setting jump-
ers. A jumper is a metal bridge used to close an electric circuit. It consists of two
metal pins and a small metal clip (often protected by a plastic cover) that slides over
the pins to connect them. To close a jumper, you connect the pins with the clip. To
open a jumper, remove the clip. Sometimes a jumper will have three pins, labeled 1,
2 and 3. In this case you would connect either pins 1 and 2, or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes. Generally, you
simply need a standard cable to make most connections.
2.2.2
Jumper List
Table 2.1: Jumper List
J1
JCMOS1
MPWR_SEL1
J_CFG2
J_CFG5
J_CFG6
J1(JSETCOM3_V1)
EIS-S232 User Manual
Auto Power On Setting (MB)
Clear CMOS (MB)
MINI PCIE Power Setting (MB)
PCIE X16 Lane Reversal Setting (MB)
PCIE X16 Bifurcation Setting (MB)
PCIE X16 Bifurcation Setting (MB)
COM3 RI Power Setting (on AMO-I028)
10
Advertisement
Table of Contents
