Table of Contents
Advertisement
BK-L216II Manual
5.5 Manual removal of the jammed paper
When any of the following errors occurs, please remove jammed paper manually
Paper jams between platen roller and cutter holder.
Paper accumulates at paper inlet of the cutter in the front of print head.
The cutter can't cut off paper.
Remove jammed paper in the following steps:
Open printer upper cover.
Pull out the jammed part of paper; if the cutter couldn't be reset, please refer to
cutter.
Cut off the folded part of paper.
Reload the paper.
6 Interface signal
6.1 RS-232 Interface
6.1.1 Parameter
data transmission mode: asynchronous serial communication
handshake mode:
voltage level:
baud rate:
data bit:
Parity bit:
Stop bit:
connector :
SNBC
Figure 5.4.1 Manual resetting cutter
RTS/CTS， DTR / DSR
MARK = -3 to -15 V: Logic "1"/ OFF
SPACE = +3 to +15 V: Logic "0"/ ON
1200, 2400, 4800, 9600, 19200, 38400, 57600,
8 bit or 7bit
None, even, or odd
1bit
9 pins serial connector(female head)
115200 bps
- 36 -
:
5.4.1 manual reset cutter
to reset the
Advertisement
Table of Contents
