Table of Contents
Advertisement
5.5 Manual removal of the jammed paper (Bundler part)
When any of the following errors of Bundler part occurs, please remove jammed paper manually.
1)
Paper is folded inside the Bundler and can not continue to forward.
2)
Paper out operation is abnormal at the Bundler paper out exit.
3)
Paper back operation is abnormal at the Bundler paper back exit.
Remove jammed paper in the following steps:
1)
Open Bundler upper path, open the Bundler upper cover if necessary.
2)
Rotate the hand-wheel on the right side of the Bundler, clear the jammed paper or manually take out
the paper by hand.
3)
Close the Bundler upper path and Bundler upper cover.
5.6 Manual removal of the jammed paper (Printing part)
When any of the following errors occurs, please remove jammed paper manually.
1)
Paper is jammed between platen roller and cutter holder.
2)
Paper accumulates at paper inlet of the cutter in the front of print head.
3)
The cutter can't cut off paper.
Remove jammed paper in the following steps:
1)
Open printer upper cover.
2)
Pull out the jammed part of paper; if the cutter couldn't be reset, please refer to figure 5.4.1 Cutter
manual-resetting to reset the cutter.
3)
Cut off the folded part of paper.
4)
Reload the paper.
6. Interface signal
6.1 RS-232 Interface
6.1.1 Parameters
Data transmission mode : Asynchronous serial communication
Handshaking:
Figure 5.4.1 Cutter manual-resetting
RTS/ CTS,DTR/DSR
- 35 -
User Manual
BK-S216
Advertisement
Table of Contents
