Rear Drive Module; Removing The 2 X 2.5-Inch Rear Drive Module - Dell PowerEdge R7615 Installation And Service Manual

Figure 54. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.

Rear drive module

Removing the 2 x 2.5-inch rear drive module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required, remove the air
4. Remove the drives.
5. Disconnect the cables from the rear drive module.
NOTE: Refer Cable routing
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the rear drive module to the system.
2. Press the blue release tab and holding the edges lift the rear drive module away from the system.
Safety instructions.
Before working inside your
shroud.
topic for more information.
system.
Installing and removing system components 97