Table of Contents
Advertisement
NOTE:
To enable the BOSS-N1 module in the system, ensure that the BIOS firmware version is 1.5.5 and iDRAC firmware
version is 4.30.30.30 or later.
Before you begin the installation or removal process, follow the
instructions.
Table 112. BOSS-N1 module kit components
R760 (quantity)
NA
1
1
1
1
1 or 2
1 or 2
2
2
1
1
To remove the BOSS blank :
1. Power off the system and
2. Use a screwdriver to push out the blank from the BOSS-N1 module bay.
Figure 216. Removing the BOSS-N1 module blank
To install the BOSS blank:
1. Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
remove the system
cover.
safety guidelines
and
before working inside the system
Components in kit
BOSS cover
M3 x 0.05 x 4.5 mm screws
BOSS signal cable
BOSS power cable
BOSS-N1 module
BOSS-N1 card carrier
M.2 SSD
M.2 240 GB information label
M.2 480 GB information label
BOSS card filler
Tech sheet
Upgrade Kits
261
Advertisement
Table of Contents
