Table of Contents
Advertisement
Figure 183. Removing the BOSS-N1 module
Next steps
1.
Replace the BOSS-N1 module
Installing the BOSS-N1 module
The procedure to install is the BOSS-N1 module with 4 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the BOSS module
Steps
1.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Align the BOSS-N1 module at an angle with the controller card module slot.
2. Insert the BOSS-N1 module and push the module horizontally towards the rear of the system until it is firmly seated.
3. Using the Phillips #1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screw.
4. Connect the BOSS-N1 power and signal cable to the connectors on the system board.
230
Installing and removing system components
or
Install the BOSS-N1 module
Safety
instructions.
Before working inside your
blank.
blank.
system.
Advertisement
Table of Contents
