Figure 121. Installing the liquid cooling heat sink
Next steps
1. If removed,
install the air
2. Follow the procedure listed in the
Expansion cards and expansion card risers
NOTE:
A system event entry is logged in the iDRAC Lifecycle Controller if an expansion card riser is not supported or
missing. It does not prevent your system from turning on. However, if a F1/F2 pause occurs with an error message,
see Troubleshooting expansion cards section in the Dell PowerEdge Servers Troubleshooting Guide at
poweredgemanuals.
shroud.
After working inside your
system.
Installing and removing system components
www.dell.com/
157