Table of Contents
Advertisement
When the memory module is properly seated in the socket, the levers on the memory module socket align with the levers on
the other sockets that have memory modules installed.
Figure 110. Installing a memory module
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
3. To ensure that the memory module has been installed properly, press F2 during reboot to enter the System Setup, and
check the System Memory setting.
The System Memory Size indicates the installed memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. . Shut down
the system and ensure that the memory modules are firmly seated in the correct sockets.
5. Run the system memory test in the system diagnostics.
Processor and heat sink
Removing a heat sink
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the air
WARNING:
The heat sink and processor are too hot to touch for some time after the system has been powered
off. Allow the heat sink and processor to cool down before handling them.
NOTE:
The procedure to uninstall standard and L-type heat sink is similar.
Steps
1. Using a Torx #T20 screwdriver, fully loosen the captive screw all the way before moving to the next screw (on one-screw-
at-a-time basis).
NOTE:
Follow the screw sequence defined on the heat sink label. Disassembly order: 6, 5, 4, 3, 2, 1
148
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
shroud.
system.
system.
Advertisement
Table of Contents
