Table of Contents
Advertisement
Figure 186. Installing the BOSS-N1card carrier
Next steps
1. Follow the procedure listed in the
System battery
Replacing the system battery
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same
or equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Locate the battery socket. For more information, see the System board jumpers and connectors section.
Steps
1. Use a plastic scribe and Press the release latch until the battery pops out.
NOTE:
Ensure that the + side of the battery is facing upwards.
232
Installing and removing system components
After working inside your
Safety instructions
that came with your system for more information.
Safety
Before working inside your
system.
instructions.
system.
Advertisement
Table of Contents
