Removing The Ocp Card - Dell PowerEdge R7615 Installation And Service Manual

Figure 194. Installing the OCP card shroud
Next steps
1. Replace the OCP card.

Removing the OCP card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
Safety instructions.
Before working inside your
riser.
system.
Installing and removing system components 239