Dell PowerEdge R7615 Installation And Service Manual page 13

Table 6. Rear view of the system with Direct Liquid Cooling (DLC) configuration (continued)
Item Ports, panels, or slots
9 Dedicated iDRAC9 Ethernet
port
10 System Identification (ID)
button
11 OCP NIC card
12 NIC ports
13 Power supply unit (PSU1)
Figure 7. Rear view of the system
Table 7. Rear view of the system
Item Ports, panels, or slots
1 PCIe expansion card riser 1
(slot 1 and slot 2)
2 BOSS module
3 PCIe expansion card riser 2
(slot 3 and slot 6)
4 PCIe expansion card riser 3
(slot 5)
5 VGA port
Icon Description
Enables you to remotely access iDRAC. For more information,
see the Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
The System Identification (ID) button is available on the front and
back of the system. Press the button to identify a system in a rack
by turning on the system ID button. You can also use the system ID
button to reset iDRAC and to access BIOS using the step through
mode. When pressed, the system ID LED in the back panel blinks until
either the front or rear button is pressed again. Press the button to
toggle between on or off mode.
NOTE:
hold the System ID button for more than five seconds to enter
the BIOS progress mode
NOTE:
page by pressing F2 during system boot), press and hold the
System ID button for more than 15 seconds.
N/A The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
The NIC ports that are integrated on the LOM card provide network
connectivity which is connected to the system board.
PSU1 is the primary PSU of the system.
Icon Description
N/A The expansion card riser enables you to connect PCI Express
expansion cards. For more information , see the
installation guidelines
N/A BOSS-N1 module.
N/A The expansion card riser enables you to connect PCI Express
expansion cards. For more information , see the
installation guidelines
N/A The expansion card riser enables you to connect PCI Express
expansion cards. For more information , see the
installation guidelines
NA Enables you to connect a display device to the system.
If the server stops responding during POST, press and
To reset the iDRAC (if not disabled on the iDRAC setup
section.
section.
section.
Expansion card
Expansion card
Expansion card
System overview 13