Wire The Terminal Base - Rockwell Automation Allen-Bradley FLEX 5000 Installation Instructions Manual

1. Make sure that the end cap is unlocked.
If the end cap is locked, pull out the tab until it clicks.
Locked
2. Align the end cap with interlocking pieces on the last connected terminal base.
3. Slide the end cap toward the DIN rail.
4. Press the locking tab until it clicks.

Wire the Terminal Base

WARNING: If you connect or disconnect wiring while the field-side power is on, an electrical arc can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is nonhazardous before proceeding.
1. Confirm that all sources of power to the module and terminal base are turned off.
2. Strip insulation from the wires that you connect to the terminal base.
TB Type
Screw
Spring
3. Connect the wires to the terminal base.
TB Type
Screw
Spring
Screw-type TB
4. Connect individual input wiring to terminals as indicated in
5. Connect cable shield ground to the shield bar accessory.
6. Connect +V DC power to terminal SA+ on the left side of the terminal base.
7. Connect V DC common to terminal SA– on the left side of the terminal base.
Unlocked
Action
2
0.34...2.5 mm (22...14 AWG) = Strip 12 mm ± 1 mm (0.47 in ± 0.04 in) of insulation from the wires
2
0.34...1.5 mm (22...16 AWG) = Strip 10 mm ± 1 mm (0.39 in ± 0.04 in) of insulation from the wires
2
2.5 mm (14 AWG) = Strip 15 mm ± 1 mm (0.59 in ± 0.04 in) of insulation from the wires
Action
1. Insert the wire into the terminal.
2. Turn the screwdriver to close the terminal on the wire. Torque the screw to 0.4 N•m (3.5 lb•in).
Push the wire into the terminal.
If the wire is too thin, crimp a wire ferrule on the wire and insert it.
Wiring Diagrams on page
Rockwell Automation Publication 5094-IN029A-EN-P - February 2023
FLEX 5000 2-channel Isolated-frequency Input Modules Installation Instructions
Tab
Spring-type TB
8.
7