Microcom 438T Operator's Manual page 82

Printer Commands
Text Mode Response
>RESTARTED<
>READY<
>CUTTER ERROR<
>TAKE LABEL<
>LOW STOCK<
>INPUT 1<
>INPUT 2<
>TRAY FULL<
>PRINTER PAUSED<
>TOF ERROR<
>OVER VDD<
>UNDER VDD<
>OVER TEMP<
>DATA ERROR<
>STOCK NOT LOADED<
>BUTTON PRESSED<
>LPD STOCK JAM<
>BROWNOUT RECOVERY<
>FAIL TIMEOUT<
>FAIL SIZE<
>NO FLASH DATA FOUND<
>CHECKSUM
VERIFICATION FAILED<
>FLASH READBACK
FAILED<
>ERASE FAILED FOR
SECTOR n<
5-12
Byte Mode
Response
1A
06
07
16
19
0E
21
09
10
1F
1E
1C
1D
15
22
Print button configured to report message
C0
Reports when jams are detected. Switch 8
11
printer will attempt to restore configuration.
Table 5-1 Enquiry Responses
Definition
Printer has been reset
Normal condition
Cutter cannot rotate
Printer is waiting for label to be taken
Media supply is low or out
Input sensor #1 active
Input sensor #2 active
Printed label tray is full
Printer is paused
Top of Form is not sensed properly
VDD voltage is out of operational range
VDD voltage is out of operational range
Print Head is too hot
Communication error
Printer power on without media installed.
when pressed.
position 8 enables this feature
Printer entered and recovered from a
brownout power condition
Timeout failure occurred using the D149
Image Print Mode
Incorrect size of the image was received
using the D149 Image Print Mode
The printer was unable to locate a valid
configuration and is forcing the default
configuration or "birth" pattern.
Configuration checksum does not match
The printer failed to read and verify the
configuration parameters are present.
The flash was unable to erase at the
memory sector noted by the "n"
438T Operator's Manual - 880051-0102
Chapter 5