Microcom 438T Operator's Manual page 219

^A ^D COMMAND
XX 91 Transmissive Detection Sensitivity: The ^Axx value sets the point (0-255) at
which the printer detects a diecut registration mark (gap) and/or blow-hole
using the transmissive sensor. The printer's threshold default is a value of 30
for the transmissive sensor. If this value is not set correctly the printer may
false sense a registration mark or report an invalid >LOW STOCK< error.
X 93 Load Control Code Recognition Status:
0 Enable control code recognition
1 Disable control code recognition
XX 95 Load Advance/Retract Distance: Used in conjunction with cutter and
dispense command. The ^Axx specifies the amount to advance after printing
and then retract to dot row. The count is given in dot increments.
XX 96 Load Advance Delay: The ^Axx specifies the amount of delay, in
Milliseconds, the printer waits before retracting to dot row in cutter and
dispense modes.
X 97 Tag/Tear Dispense Mode:
0 Disables Tag/Tear Mode
1 Advance after every label.
2 Advance after copies count.
3 Advance when idle.
X 98 Peel-n-Dispense Mode:
0 Disable Peel-n-Dispense
1 Enable Peel-n-Dispense
X 99 Cutter Control: This command enables the volatile full and/or partial cut
operation. This command works in conjunction with the ^D102 and ^D103 Cut
Interval commands. The ^D95 command is also used with the ^D99 command
to adjust the advance distance to the cutter blades and then retract to the
home position (dot row one).
0 Disable Cutter operation.
1 Enable Full Cut.
2 Enable Partial Cut.
3 Enable Full and Partial Cut.
100 Clear User RAM: This command clears all the downloaded fonts and graphics
that have been stored in RAM.
101 Send User RAM Available: The printer will send the number of free or
available bytes to the serial port (i.e. >192480<). Use the D119 command for
additional reporting.
438T Operator's Manual - 880051-0101 13-13