Microcom 438T Operator's Manual page 113

Chapter 5
^A ^D COMMAND
XX 64 Auto-Print String Count: This command is used in conjunction with the
^A1^D63 auto-print command. The ^Axx specifies the number of text strings
(carriage returns) to accept before issuing the print command. When the
printer is in the auto-print mode, it is not necessary to send the ^D2 command
to enter text or the ^D3 command to initiate printing. The printer will accept
incoming text strings and print the label as soon as the number of strings
equal the amount specified by the ^D64 command.
The following is an example of the ^D61, ^D63, and ^D64 commands:
^A0^D64<CR>
^D57<CR>
6,1280,900,,38,7,0,1,395,0,0 <CR>
1,300,300,20,1,4<CR>
2,300,250,20,1,4<CR>
3,300,200,20,1,4<CR>
4,300,150,20,1,4<CR>
5,300,100,20,1,4<CR>
6,300,50,20,1,4<CR>
^D56 <CR>
^D2 <CR>
Protected Field<CR>
Protected Field<CR>
Protected Field<CR>
Variable Field<CR>
Variable Field<CR>
Variable Field<CR>
^A3^D63<CR>
^A3^D64<CR>
^A3^D61<CR>
5.9 Cutter Configuration Commands
5.9.1 Cutter Type
The ^D115 is a non-volatile command that sets the proper type of cutter installed on the
printer being used. This value is reported to the ^D29 statistics label. This command
should be used prior to enabling the cutter with the ^D99 or ^D111 commands.
^A ^D Command
X 115 Set Cutter Type
0 No Cutter
1 Guillotine
2 Rotary
438T Operator's Manual - 880051-0102
(Clears any old settings)
(Enables Auto-Print and Clears text)
(Instructs printer to print after 3 <CR>)
(Instructs printer to start text entry at line 3 instead
of line 1)
Printer Commands
5-43