Horn - Toro Outcross 9060 Series Installation Instructions Manual

5
Installing the Horn
Parts needed for this procedure:
1

Horn

Attaching the Horn to the Machine
1. At the frame of the machine below the right-front engine bracket, remove the flange locknut (5/16 inch)
from the bolt (5/16 x 2-3/4 inches) that secures the coolant-reservoir bracket to the frame
1. Bolt (frame/bracket 5/16 x 2-3/4 inches)
2. Flange locknut (5/16 inch)
2. Assemble the bracket of the horn onto the bolt (5/16 x 2-3/4 inches) with the flange locknut (5/16 inch),
and torque the bolt and nut to 1978 to 2542 N∙cm (175 to 225 in-lb).
Figure 6
Figure 7
3. Right-front engine bracket
7
g254486
(Figure 7).
g254490