Toro Outcross 9060 Series Installation Instructions Manual page 13

3. Install the bracket and relay using the 2 bolts previously removed
4. Install 4 clipnuts onto the bracket
5. Install the dual flasher onto the bracket using 4 bolts (#10 x 1/2 inch) (Box A of
6. Connect the harness to the dual flasher (Box B of
7. Route the harness under the control panel and connect it to the machine wire harness (Box B of
1. Machine wire harness
8. Install the control panel.
(Figure 18).
Figure 18
Figure
Figure 19
2. Kit wire harness
13
(Figure 18).
Figure
19).
g274359
19).
Figure 19).
g278144