Toro Outcross 9060 Series Installation Instructions Manual page 4

2. Remove the bolts and nuts on the left side of the machine as shown in Box A of
Note:
Remove hardware from one side at a time.
3. Secure the tail light assembly and bracket to each side of the machine using 4 bolts (5/16-18 x 1 inch)
and 4 nuts (5/16 inch).
4. Repeat on the right side of the machine.
5. Route the tail light assembly wire harnesses up through the roof assembly as shown in Boxes C and D
in Figure 3.
Figure 3
4
Figure 3.
g264165