Toro Outcross 9060 Series Installation Instructions Manual page 2

Procedure
11
12
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface, move the
shift lever to the N
the attachments.
2. Engage the parking brake, shut off the engine,
remove the key, and wait for all movement to
stop before leaving the operator's seat.
3. Disconnect the battery; refer to the electrical
system maintenance section of the traction unit
Operator's Manual.
Description
Yellow reflective tape
Red reflective tape
No parts required
position, and lower
EUTRAL
Qty.
2
Install the reflective tape.
4
–
Install the roof panel.
2
Removing the Roof Panel
No Parts Required
Procedure
1. Remove the 6 flange-head bolts and 6 washers
that secure the roof panel to the roof-mount
channel (Figure
1. Washer
2. Flange-head bolt
2. Carefully lift the roof panel from the machine
(Figure 1).
2
Use
1).
Figure 1
3. Roof panel
4. Roof-mount channel
g254272