Toro Outcross 9060 Series Installation Instructions Manual page 6

Note:
Coil the excess harness up under the roof when the license plate light kit is not used. Secure the
harness using the push mount fastener and cable tie to the roof rail
7. Insert the push mount fasteners in the holes on the frame
1. Machine wire harness
2. Kit wire harness
3. Right rear light harness
Figure 5
4. Push mount fasteners
5. Right front light harness
6. Left rear light harness
6
(Figure 5).
(Figure 5).
7. Left front light harness
8. Excess harness
g274364