Table of Contents
Advertisement
In the event of a malfunction, fi rst check all the cable connections and operating states:
1. Receiver and TV set power plugs are connected to wall socket
2. Antenna cables are connected to the receiver input
3. Receiver and TV set are correctly connected to each other by a HDMI or Scart or cinch cable
4. Audio connections are made to the Hi-Fi or Dolby Digital system as appropriate
5. Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)
6. Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem
A "No signal!" warning appears
on some or all channels
Remote control no
longer responding
Wrong time being displayed
Internet: http://www.kathrein.de
KATHREIN-Werke KG • Anton-Kathrein-Straße 1 - 3
P.O. Box 100 444 • 83004 Rosenheim GERMANY
TROUBLESHOOTING
Cause
Antenna signal is absent
or is defective.
Receiver or remote control
command set may have been
unintentionally changed
"Summer Time" setting wrong.
An incorrect time was imported
from the reception signal
Remedy
Check the cable connection
between your receiver
and the cable socket.
Refer to your cable network
operator or an antenna specialist.
Set infrared code 1 as described
in this manual under "Main
menu settings", "Basic settings",
"Setting the remote control
code", check the batteries
On "Settings" - "Date and Time"
setup menu check "Summer
Time Enabled" and change as
necessary Use the power switch
to switch the receiver off from the
current channel, e.g. Das Erste
or ZDF, wait 10 seconds and
then switch it back on
Advertisement
Table of Contents
